GenCore Power Protection Insights

Blog

Four Things Plant Engineers Get Wrong About 700 kW Cummins and Perkins Sets

Posted on Wednesday 17th of June 2026 by Rebecca Sloan

Cummins vs Perkins generator — An aggregates quarry needed standby for its primary crusher feed and weighbridge offices. The shortlist came down to a Cummins QSK-family set and a Perkins 4000-series set at the same ~700 kW. [...]

Continue Reading →

Posted in Blog

Leave a comment

Blog

"Why does my 1000 kW airport set keep failing the witnessed block-load test — and would the other brand pass?"

Posted on Wednesday 17th of June 2026 by Rebecca Sloan

Cummins vs Caterpillar generator — An airport's new standby set — feeding the airfield lighting regulators and the terminal's life-safety loads — keeps dipping too far on the witnessed step test. [...]

Continue Reading →

Posted in Blog

Leave a comment

Blog

The moment the compressors re-strike: which standby set trips first, and why the nameplate won't tell you

Posted on Wednesday 17th of June 2026 by Rebecca Sloan

Cummins vs Kohler-SDMO generator — A regional cold-storage distribution centre holds about 700 kW of refrigeration plant on its standby bus. [...]

Continue Reading →

Posted in Blog

Leave a comment

Blog

4 Numbers That Kill the “Maintenance-Light” Myth: Cummins vs SDMO Generator

Posted on Wednesday 17th of June 2026 by Rebecca Sloan

Cummins vs Kohler-SDMO generator — You hear it constantly: “Just buy a generator that doesn’t need much looking after.” That’s a myth — a dangerous one when you’re sizing a panel that’s supposed to run unattended. [...]

Continue Reading →

Posted in Blog

Leave a comment

Blog

5 Numbers That Decide the Cummins vs Caterpillar Generator Question — & Why Maintenance-Light Tips the Odds

Posted on Wednesday 17th of June 2026 by Rebecca Sloan

Cummins vs Caterpillar generator — Here’s the myth: “You buy Caterpillar when you never want it to fail.” True enough — a C32 at standby rating is a monument of endurance. [...]

Continue Reading →

Posted in Blog

Leave a comment

Blog

Declared, Undeclared, Inferred: Reading a Cummins QSK vs KOHLER-SDMO D830 Quote for an N+1 Data Hall

Posted on Wednesday 17th of June 2026 by Rebecca Sloan

Cummins vs Kohler-SDMO generator — A colocation operator building an N+1 standby plant for a single data hall asked for two like-for-like quotes: a Cummins QSK set in its lower band and a KOHLER-SDMO D830 (about 750 kW prime / 825 kVA standby),… [...]

Continue Reading →

Posted in Blog

Leave a comment

Blog

Cummins vs Caterpillar Generator: runtime under real load

Posted on Wednesday 17th of June 2026 by Rebecca Sloan

Cummins vs Caterpillar generator — “A Caterpillar generator runs longer on a full tank than a Cummins of similar rating.” This shows up in contractor circles and occasionally in tender notes — the idea that Cat iron has a lower specific fuel… [...]

Continue Reading →

Posted in Blog

Leave a comment

Blog

The Lifetime-Cost Myths Behind a 900 kW Cummins vs Caterpillar Choice at a Semiconductor Fab

Posted on Wednesday 17th of June 2026 by Rebecca Sloan

Cummins vs Caterpillar generator — A wafer fab cannot tolerate a process excursion from a power blip — a single bad transient can scrap a lot worth more than the genset. [...]

Continue Reading →

Posted in Blog

Leave a comment

Blog

“Efficiency you can actually keep” — the eligibility gate between Cummins and SDMO diesel generators

Posted on Wednesday 17th of June 2026 by Rebecca Sloan

Cummins vs Kohler-SDMO generator — COST OF ERROR You pick a 250 kVA SDMO D275 because the brochure says 38.1 L/hr at 75% load. That number is real — but only if you wire the generator into a system that actually lets it run at 75% load factor. [...]

Continue Reading →

Posted in Blog

Leave a comment

Blog

"At 650 kW, does prime or standby rating decide my Cummins-vs-Perkins choice — or am I asking the wrong question?"

Posted on Wednesday 17th of June 2026 by Rebecca Sloan

Cummins vs Perkins generator — A district-heating plant operator wants one 650 kW set to backstop the circulation pumps and the gas boosters. The honest answer takes four stages, and the threshold only appears at the end. [...]

Continue Reading →

Posted in Blog

Leave a comment